Fastening Front And Rear Seatbelts - Toyota AURION Owner's Manual

OCCUPANT RESTRAINT SYSTEMS
It is essential to replace the entire as-
sembly after it has been worn in a severe
impact even if damage to the assembly
is not obvious.
Belts should not be worn with straps
twisted.
Each belt assembly must only be used
by one occupant; it is dangerous to put
a belt around a child being carried on
the occupant's lap.
WARNING: No modifications or addi-
tions should be made by the user which
will either prevent the seatbelt adjusting
devices from operating to remove slack,
or prevent the seatbelt assembly from
being adjusted to remove slack.
58
—Fastening front and rear
seatbelts
Buckle
Adjust the seat as needed and sit up
straight and well back in the seat. To
fasten your belt, pull it out of the retractor
and insert the tab into the buckle.
You will hear a click when the tab locks into
the buckle.
The seatbelt length automatically adjusts to
your size and the seat position.
The retractor will lock the belt during a
sudden stop or on impact. It also may lock
if you lean forward too quickly. A slow, easy
motion will allow the belt to extend, and you
can move around freely.
If the seatbelt is allowed to retract too quickly,
it may lock in the retracted position. To re-
lease the belt, firmly pull the belt and release
it. You will then be able to smoothly pull the
belt out of the retractor.
The rear seatbelts have an additional locking
feature used to hold a child restraint system
securely. When this feature is activated, the
seatbelt is locked from extending from the
last retracted position. For details about this
feature, see "Child restraint" on page 78 in
Section 1--3.
To unlock the seatbelt, unbuckle the belt,
allow it to fully retract then pull it out again.
Tab