Memory Call System Using Memory Buttons - Toyota AURION Owner's Manual

—Memory call system using
memory buttons
SETTING THE DRIVING POSITION
The ignition switch must be set to ON and
the selector lever is in the "P" position.
1. Adjust the driver's seat, steering wheel
and outside rear view mirrors to the de-
sired position.
2. While pressing the SET button, press
button "1" or "2" until a beep is heard.
The system can memorise up to 2 positions
by repeating the above steps. If step 2 is per-
formed when both buttons "1" and "2" are
memorised, the previous position will be er-
ased and a new position will be set.
To make only slight changes to an already
memorised position, the easiest way is to
first activate the memorised position, then
make the desired changes and perform step
2 above.
OCCUPANT RESTRAINT SYSTEMS
RECALLING THE MEMORISED POSITION
When you press button "1" or "2", a beep
will sound and the driving position will be
automatically adjusted to the position re-
corded for that button.
The memorised position can be recalled
under the following conditions:
The ignition switch is set to ON and the
D
selector lever is in the "P" position.
The ignition switch is turned off, and less
D
than 30 seconds have passed since open-
ing the driver's door.
To stop the operation, press any driving posi-
tion memory button.
To reactivate the system, press the button "1"
or "2" again.
If the vehicle's battery is disconnected, the
memory will be erased and the positions will
have to be set again.
CAUTION
Do not start the vehicle while making
D
adjustments to the driving position.
To avoid striking the rear passenger
D
with your seat or hitting your body
against the steering wheel, take care
when pushing the buttons to select a
memorised driving position.
51