Sony HXR-NX80 Service Manual page 89

12. Remove the P frame moving assembly in the direction of the arrow.
13. Check that the adhesive fixing portion of the magnet is not peeled off. If peeling can be confirmed, apply adhesive
(B-110).
Note
Be careful not to exceed the application range of adhesive.
Top
14. Remove the moving shaft of the new P frame moving assembly and clean the grease adhering to the shaft and the
bearing portions with ethanol.
Note
P frame moving assembly and guide shaft are shipped in combination that keeps the clearance of shaft diameter
constant. Be sure to use in combination provided.
P frame moving assembly
15. Install the P frame moving assembly in the reverse order of steps 9 to 10.
HXR-NX80/HXR-MC88
P frame moving assembly
Side
Magnet
Bearing portion
Moving shaft
Adhesive
Application range
3-63