Sony HXR-NX80 Service Manual page 24

Self-diagnosis Code
Block Detailed
Function Code
E 6 2 1 2
E 6 2 2 0
E 6 2 3 0
E 9 1
*1
0 1
E 9 1 *1
0 2
E 9 1
*1
0 3
E 9 2 0 0
E 9 2 0 1
E 9 4 *1
0 0
E 9 4
*1
0 1
E 9 4 0 2
E 9 5
0 0 *1
E 9 5
0 1 *1
E 9 5 *1
0 2
E 9 6
*1
0 0
E 9 7 *1
0 0
*1: Function of this code is not provided in this unit.
HXR-NX80/HXR-MC88
Symptom/State
Shift lens overheating (YAW)
Abnormality of thermistor
Abnormal CPU
Abnormality when flash is being
charged
Abnormality of LED video light
Abnormality of LED video light
Temperature detection
Battery/Dry cell distinction defect
Battery current value goes over the
max discharge current
Fault of writing or erasing the inter-
nal memory
Abnormality of the internal memory
BGM data error
GPS hardware error
Acceleration sensor hardware error
Electronic compass hardware error
(GPS hardware error)
Map area mount error
Projector hardware error
Correction
Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
Check signal line connections from CPU through steady-
shot IC to PITCH/YAW drive.
When there is no problem with the connections, check
whether this error is due to the lens or the board. Replace
the faulty lens or board.
Turn power off and turn power on again. When this error is
not cleared, replace the board that mounts the CPU.
Check or replace the LED flash/video light or charging ca-
pacitor.
Check or replace the LED flash/video light or charging ca-
pacitor.
Check or replace the LED flash/video light or charging ca-
pacitor.
Turn power off and turn power on again.
Confirm whether or not the symptom is occurred after re-
placing the battery. If the symptom is still occurred, replace
board.
Turn power off and turn power on again.
Turn power off and turn power on again.
The CPU may be faulty.
Replace the board that contains this peripheral circuit.
Check the signal line connection for GPS.
When there is no problem with the connections, replace the
board that contains this peripheral circuit.
The acceleration sensor may be faulty.
Replace the board that contains this peripheral circuit.
The peripheral circuit of the electronic compass may be
faulty.
Replace the board that contains this peripheral circuit.
The flash memory may be faulty.
Replace the board that contains this peripheral circuit.
The peripheral circuit of the projector may be faulty.
Replace the board that contains this peripheral circuit.
2-4