Device setup
The following shows the setup procedures of devices.
Personal computer setting
Operating procedure
1.
Install Configuration Tool.
Page 62 INSTALLATION AND UNINSTALLATION
2.
Copy the sample file under the "Library" folder in the compressed file.
Example: Copy the "Library\Samples\C#" folder in the compressed file to the C drive.
C Drive
C#
This product (SW1DNN-RDCUTL-E)
Library
Samples
Sample.rdcp
C#
3.
Set the IP address of a personal computer to "192.168.3.1."
This setting can be set in the "Internet Protocol Version 4 (TCP/IPv4) Properties" screen.
Programmable controller system setting
Operating procedure
1.
Mount a power supply module, CPU module, and high speed data communication module on a main base unit.
MELSEC iQ-R Module Configuration Manual
2.
Insert an SD memory card in the high speed data communication module.
Page 53 Insertion/removal method of an SD memory card
3.
Set parameters and write them to the CPU module in the engineering tool.
Page 48 Parameter setting
Copy the sample file.
8 OPERATION EXAMPLE
8.1 Setup
8
65