Device Setup - Mitsubishi Electric MELSEC iQ-R Series User Manual

Device setup

This section shows the setup procedures of devices.
Personal computer setting
Operating procedure
1.
Install MX OPC UA Module Configurator-R.
2.
Set the IP address of a personal computer to '192.168.3.100'.
This setting can be set on the "Internet Protocol Version 4 (TCP/IPv4) Properties" screen.
Programmable controller system setting
Operating procedure
1.
Mount a power supply module, CPU module, and OPC UA server module on a main base unit.
MELSEC iQ-R Module Configuration Manual
2.
Insert an SD memory card into the OPC UA server module.
Page 44 Insertion/removal method of an SD memory card
3.
Set parameters and write them to the CPU module in the engineering tool.
Page 39 Parameter Setting
For details on the parameter setting and programming in the engineering tool, refer to the following:
GX Works3 Operating Manual
8 OPERATION EXAMPLE
58
8.1 Setup