Operations For Replacing An Sd Memory Card - Mitsubishi Electric MELSEC iQ-R Series User Manual

Operations for replacing an SD memory card

Follow the procedure below to replace the SD memory card with a new card. Also, make sure to stop file access before
removing the SD memory card.
1.
Turn the power of a CPU module ON when it is OFF.
2.
Start Configuration Tool, and read settings.
3.
Stop file access to prohibit reading/writing to an SD memory card. (Page 52 Method for stopping file access)
4.
Remove the SD memory card. (Page 53 Removal procedure)
5.
Insert a new SD memory card. (Page 53 Insertion procedure)
6.
Check if the SD memory card is correctly inserted into the high speed data communication module. (If the CARD RDY
LED is ON, it is correctly inserted.)
7.
Write settings and execute "Update settings" in Configuration Tool.
*1 For details on reading settings, writing settings and "Update settings," refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
If an error occurs on an SD memory card, refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
Precautions
High speed data communication module settings are saved on an SD memory card. Therefore, the IP address of the high
speed data communication module returns to the initial status (192.168.3.3) when turning the power OFF and ON or resetting
a CPU module without an SD memory card inserted in the module or without the settings written to the SD memory card.
As necessary, read the current settings before removing the SD memory card, and promptly write those settings to the new
card after replacing the card.
*1
*1
4 PROCEDURES BEFORE OPERATION
4.2 SD Memory Card
4
51