Table of Contents
Advertisement
10.0 - REPLACING REMOTE CONTROL BATTERIES
When the remote control batteries are too weak (see par. 2.0), replace them as
follows:
!
Separate the remote shells taking care not to damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new batteries taking care not to invert polarity.
!
Close the remote shells.
!
Make sure the remote control works properly.
WARNING
!
Use only CR1616 batteries.
There is a serious risk of explosion if batteries are replaced by an
incorrect type.
Different type batteries can also seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers.
11.0 - TECHNICAL SPECIFICATIONS
Power supply
Power supply range
Current absorption @ 12Vdc
Current absorption in
sleep mode
Siren sound level
Relay capacity
Turn indicator output
PAGE15
BATTERIES
12 Vdc
9Vdc-15Vdc
<
2mA
(system armed and LED
flashing
)
< 1
mA
118 dBA @ 1 m
8A
12V max. (6A max. per side)
12.0 -
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) as specified in art. 2.1 of
Leg. Decree n. 151 of 25/07/2005.
13.0 - USE AND MAINTENANCE
Care should be taken to protect the electronic alarm system
!
Do not clean the alarm unit with water but use a damp cloth to wipe.
!
Do not use voltages other than the one specified by the manufacturer
!
Protect the alarm from any direct water flow such as high-powered water
jets found in a car wash.
ATTENTION
!
Gemini Technologies
will not be held responsible for any damage
caused by improper
14.0 - WARRANTY CONDITIONS
This product is guaranteed for 24 months from the date of purchase in
accordance with the provisions set forth in Leg. Decree
September
6, 2005 ("Italian Consumer Sales Code") and subsequent
amendments.
The product certificate, duly completed and accompanied by the original sales
receipt will constitute proof of purchase.
The warranty shall be void if labels on the product or on the certificate are
missing or torn, if the certificate is not fully completed or if the enclosed sales
receipt is missing.
The manufacturer is
NOT
responsible for any aspect of installation, after-sales
service and/or technical support and, should these services be included in the
sales contract, they will be the exclusive responsibility of the retailer.
Consumers who need to enforce their statutory consumer guarantee rights
against defective products - in accordance with Art. 128 et seq. of the Italian
Consumer Sales Code (Leg. Decree n.206 as above)- must personally contact
the retailer.
The manufacturer declines any responsibility for eventual malfunctions or
failures of the product and/or any damage whatsoever caused by improper
installation, use or tampering.
This alarm system is solely intended to be a theft-deterrent device.
:
.
use.
n.206
dated
PAGE 16
Advertisement
Table of Contents
