Table of Contents
Advertisement
INSTALLER MANUAL
15.0 - FITTING INSTRUCTIONS
Please read all instructions and understand them thoroughly before starting
the installation.
The present manual is to be considered an integral part of the alarm
system.
16.0 - ALARM UNIT SEALING
To seal the alarm, position the
rubber cap over the external edge of
the alarm housing as shown below.
Pull the plastic rectangular flange
over the rubber cap and secure with
the supplied screws.
Do not over tighten the screws.
Alarm unit sealed
PAGE17
17.0 - ALARM UNIT POSITIONING
Since the alarm has a built-in high sensitivity triaxial sensor, it can be positioned
either vertically or horizontally as long as you keep the following
Do not install the alarm unit in this
position as water ingress over time
may seep through the rubber sheath
and permanently damage the
NO!
electronic circuit making the alarm
Eventual malfunctioning due to water
infiltration is not covered by warranty.
!
Fitting the alarm in this position will prevent water
entering the unit.
!
It is important to give the rubber sheath a "
neck"
bending as shown in the picture opposite and
secure with a tie wrap.
!
Do not expose to atmospheric agents.
!
Pay attention not to muffle the siren speaker.
!
Secure away from moving mechanical parts.
!
Keep away from devices that could generate high
OK!
frequency electromagnetic disturbances.
!
Keep away from devices that could reach high
temperatures when the vehicle is in use.
!
Do not secure the alarm unit directly on the vehicle
frame.
!
ATTENTION
Do not jet wash the alarm ECU.
The warranty will not cover damages to the alarm system due to water
ingress caused by improper installation or jet washing.
in mind
:
unreliable.
goose-
PAGE 18
Advertisement
Table of Contents
