Advertisement
REPLACING REMOTE CONTROL BATTERIES
The remote control operates using alkaline batteries.
Under normal use conditions of the remote control these will gradually lose
their charge.
The more you use the remote control, the sooner the batteries will become
discharged.
To prevent problems with the remote control, it has been provided with a device
that will signal the charge condition of the batteries inside.
During normal use of the remote control, when you press a command button
the green transmission LED will light up with a steady light.
If the battery charge drops below the level needed to assure correct operation
of the remote control, when you press a command button the green
transmission LED will blink, advising you that it is time to replace the batteries.
For battery replacement follow the indications reported below.
Separate the plastic shells of the remote control paying attention to not
damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new batteries in their housing, being careful to not invert the
polarity.
!
Close the plastic shells of the remote.
!
Verify the efficiency of the remote control.
BATTERIES
WARNING:
Use only type CR1616 batteries.
Using batteries different from those advised can seriously damage the remote
control unit.
Do not discard used batteries in the environment; they should be disposed of in
appropriate containers.
PAG.10
USE AND MAINTENANCE
Please note that the alarm system is still an electronic device, so must be
handled carefully.
The following are simple hints which are useful if you want to prevent device
damage because of an improper use.
!
Do not clean the alarm with water.
!
Do not expose the alarm to heat sources.
!
Do not use power supply voltages which are different than those specified
by the factory label.
!
If the motorbike is cleaned with a washing machine, be careful not to
directly expose the alarm to the water jets.
!
Use a damp cloth to clean the alarm.
WARNING
!
GEMINI TECHNOLOGIES S.p.A. IS NOT RESPONSIBLE FOR DAMAGES
TO THE ALARM IN CASE OF AN IMPROPER USE OF IT.
WARRANTY CONDITIONS
This apparatus is guaranteed against all defects of fabrication for a period of 24
months from the installation date shown on the warranty coupon below, taking
into consideration the 1999/44/CE.
Please fill in the warranty certificate contained in this instruction booklet in all its
parts and DO NOT REMOVE the warranty label on the apparatus.
If the warranty label is lost or damaged or if the data on the warranty certificate
is not complete or if the attached sale document is missing, the will not
recognize this warranty.
The warranty is valid exclusively at centers authorized by Gemini
S.p.A.
The manufacturer declines all responsibility for any defects or malfunctions of
the alarm and of the vehicle electric system if the apparatus is installed
incorrectly, mishandled or improperly used.
The alarm has only a dissuasive function against thefts.
NOTE: Any type of modification or addition not expressly indicated on
the installator manual or authorized by Gemini Technologies S.p.A., will
invalidate automatically the installation certificate and product warranty.
Technologies
PAG.11
Advertisement
