........PAGE 09 7.1 - Optical signals......................To arm the system without arming interior protection press button “3” on the Gemini remote control. PAGE 09 7.2 - Audio signals......................System arming is confirmed by a siren chirp and a flash of the turn indicators (if signals are enabled).
CORRECT installation examples Wire tampering LED OFF (2 seconds) LED ON (1 second) 2.0 - GEMINI REMOTE CONTROL 738W AND BATTERY REPLACEMENT If the right connections have been made, the vehicle doors will lock/unlock when pressing INCORRECT installation examples the arming/disarming buttons.
Optical signals activated by connection to the Hazard switch will ONLY turn ON during an alarm condition (See available diagrams in the restricted area of our website: www.gemini-alam.com). ORANGE wires turn indicator flashes for all optical signaling functions (factory enabled). PAGE 07...
After 4 more seconds, the LED will flash for the third and last time. Press the button at the 3rd flash which corresponds to number “3”. 8.0 - SYSTEM PROGRAMMING EXAMPLE 3rd FLASH Press Gemini remote control button “ ” to enable programmable functions and button Press “...
A quick high-pitched chirp, long low pitched chirp and 2 flashes of the turn indicators will confirm the 10.0 - LEARNING NEW DEVICES system is in programming mode. To carry out the operation successfully, make sure the required electrical connections enable the functions press once the “ON”...
11.0 - DELETING PROGRAMMED DEVICES 13.0 - TECHNICAL SPECIFICATIONS 932MHW UNIT : To carry out the operation successfully, make sure the required electrical connections (bonnet switch and ignition) are properly connected. Power supply 12Vdc If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15).