Table of Contents
Advertisement
7.0 - PIN CODE OVERRIDE
If you cannot disarm the system from the remote controls because they are lost
or broken or batteries are flat, you will be able to disarm the system by using the
PIN override procedure.
For security reasons, we recommend that you change the 4-digit PIN code
from the factory setting 1-1-1-1 (par. 9.0).
To override the system:
!
Trigger an alarm condition. After the warning signals, the status LED will
turn ON steady for approx. 5 sec.
!
While the LED is ON, cycle ignition key ON and then OFF
CAUTION
If ignition key stays in the ON position for more than 5 sec., the system will
interpret the situation as a theft attempt and trigger another alarm.
!
The status LED will turn OFF to confirm the system is in override mode.
!
4 sec. after the LED has powered OFF, there will be a
flashes
.
!
Count the number of flashes and, at the number of flashes that equals the
PIN 1st digit, cycle ignition key ON and OFF to confirm the entered digit.
!
After 4 seconds,
there will be another sequence of LED flashes
!
When the number of flashes equals that of the 2nd digit, cycle ignition key
ON and OFF to confirm the entered digit.
!
Repeat the above steps for the remaining two digits.
!
If the code has been entered correctly, the system will disarm and signal the
last cause of alarm (par. 3.11, "System disarming with alarm memory .
CAUTION
If the LED blinks more than 9 times, the procedure will be invalidated and
considered a theft attempt.
PAGE 11
To help you understand the override procedure by PIN code, here below is a
step-by-step example entering PIN code "2-3-4-1".
Arm the system. After the arming delay, trigger an alarm condition.
.
After the alarm warnings are over, the status LED will turn ON steady for
approx. 5 sec. While the LED is ON, cycle ignition key ON and OFF; the
LED will go OFF to confirm the system is in PIN override mode.
LED ON
approx. 5"
sequence of 9 LED
After 4 sec. the LED will flash 9 times in sequence. Count the number of
flashes
and cycle ignition key ON and OFF when the number of flashes
.
After 4 sec., there will be another sequence of LED flashes. Cycle ignition
key ON and OFF after the 3rd blink (PIN code 2nd digit "3").
4 Sec
.
")
First digit: "2"
Repeat the above steps for the remaining two digits ("
4 Sec
.
If the PIN code has been entered correctly, the alarm system will disarm
If the LED blinks more than 9 times, the procedure will be invalidated and
8.0 - PIN CODE OVERRIDE EXAMPLE
Key "ON"
Alarm condition
Key
Key
"O "
N
"OFF"
equals that of the 1st digit
(in this case "2")
4 Sec.
"ON" "OFF"
Second digit: "3"
Third digit: "4"
"ON"
"OFF"
and signal the last cause of alarm (see par. 3.11).
considered a theft attempt.
Key "OFF"
L
ED
OFF to
confirm
override mode
.
"ON"
"OFF"
4" and "1"
).
4 Sec.
Fourth
"ON"
"OFF"
digit: "1"
PAGE 12
Advertisement
Table of Contents
