Table of Contents
Advertisement
24.0 - PROGRAMMABLE FEATURES
To either enable or disable one of the programmable features, proceed as
follows:
NB: Remember to ALWAYS arm/disarm the system before programming.
1
With the system disarmed, lift the seat
or open the topcase (if protected by a
contact switch) otherwise ground the
NB: Remove the wire from ground after
2
Turn ignition key in ON.
3
The status LED will light up for approx. 1 sec.
4
While the LED is ON, simultaneously press
both remote control buttons.
Two confirmation tones (1 Bop and 1 Beep)
will acknowledge the system is in
The LED will light up steady.
PAGE 25
GREEN/BROWN wire.
programming.
programming mode.
After pressing both buttons simultaneously (step 4), program the features
according to your needs.
TO ENABLE
Press button 1
Button 1: ENABLE
ACOUSTIC SIGNALS
(factory enabled)
Button
Button
PANIC
ALARM
(
factory enabled
)
Button
Button
TILT SENSOR
(factory enabled)
Button
Button
PASSIVE ARMING
(
factory disabled
)
Button
Button
ANTI-HIJACK
(
factory disabled
)
Button
Button
PRE-ALARM
(
factory disabled
)
Button
SYSTEM SELF-REARMING
Button
(
factory disabled
)
Button
TO DISABLE
Press button 2
2: DISABLE
1:
ENABLE
2:
DISABLE
1:
ENABLE
2:
DISABLE
1:
ENABLE
2:
DISABLE
1:
ENABLE
2:
DISABLE
1:
ENABLE
2:
DISABLE
1:
ENABLE
2:
DISABLE
EXIT PROGRAMMING
PAGE 26
Advertisement
Table of Contents
