Table of Contents
Advertisement
2.0 - FUNZIONAMENTO TELECOMANDO E SOSTITUZIONE BATTERIA
3.0 - OPTIONAL DEVICES AND BATTERY REPLACEMENT
Remote controls have a low charge battery indicator that gives early warning to avoid malfunctioning. When the
batteries are fully charged the LED shows a steady light at the press of a button while, if the batteries are low, the
LED blinks.
3.1 - TWO-BUTTON REMOTE CONTROL - 7208E
Button 1: Arming
Button 2: Disarming
REPLACING THE BATTERIES:
!
Separate the remote shells taking care not to damage the internal circuit.
!
Remove the discharged batteries.
!
Insert the new batteries. Pay attention not to invert the battery polarity.
!
Close the remote shells.
!
Make sure the remote works properly.
BATTERIES
3.2 - FOUR-BUTTON REMOTE CONTROL - 848/ALG
Button 1:
Total system arming
& door lock
Button 3:
Partial arming
(sensor exclusion
& door lock).
REPLACING THE BATTERY:
1
Different type batteries can seriously damage the remote control
Discard used batteries properly in special dedicated containers.
PAGE 06 - USER GUIDE
LED
indicator
Button 1
Button 2
!
ATTENTION
Use only CR1616 batteries.
batteries can seriously damage the remote
control
Discard used batteries properly in special
dedicated containers.
Button 2:
System disarming
& door unlock
Button 4
:
N/A
2
3
!
ATTENTION
Use only CR2032 batteries.
3.3 - RFID TRANSPONDER - 908
To activate the transponder simply presss the button and keep it pressed for at least 4 sec. The LED
turns ON steady when the transponder is activated. Release the button. The LED will flash everytime
data is transmitted.
If no movement is detected within 10 min. the transponder automatically goes into standby mode to
save battery life; to wake it up for another 10 min., move it or press the button. Press the button again to
send a radio signal to the alarm system.
To switch OFF the transponder, press and hold the button for approx. 10 sec., the LED will be ON
steady. It will flash twice just before the transponder switches OFF.
REPLACING THE BATTERY
Separate the shells and
carefully remove the
circuit.
Different type
.
4
.
to disable the engine immobilizer.
:
1
Reassemble the shells, turn
ON the tansponder and
make sure it works.
3
!
ATTENTION
Use only CR2032 batteries.
Different type batteries can seriously damage the transponder
Discard used batteries properly in special dedicated containers.
Slide out the dead
battery and insert the
new one. Pay attention
not to invert polarity.
+
2
.
USER GUIDE - PAGE 07
Advertisement
Table of Contents
