Table of Contents
Advertisement
9.0 - PIN CODE CUSTOMIZATION
Here below is a step-by-step example showing how to customize the factory
PIN code. In this case the selected PIN code is
D
isarm the alarm system
Ground the BROWN-GREEN wire.
BROWN-GREEN
GROUND
Turn ignition key "ON"
Key "ON"
The status LED will light up for approx.1 sec.
While the LED is ON, simultaneously press both remote control buttons.
2 Beeps will sound and the LED will power ON steady.
1 sec.
Disconnect the BROWN-GREEN
wire.
BROWN-GREEN
GROUND
PAGE 13
2-3-4-1
.
.
Open the seat (if protected by a
contact switch).
.
Steady
Bop
Bop
ON
Close the seat if previously opened.
Simultaneously press both
The LED will turn OFF
Turn ignition key "OFF"
After 4 sec., the LED will flash 9 times in sequence.
Count the number of flashes and cycle ignition key ON and OFF when the
number of flashes equals that of the new PIN code 1st digit.
Key
"ON"
After
4 sec.,
there will be another sequence of LED flashes
Repeat the above step to enter the
Key
"ON"
Repeat the above steps to enter the last 2 digits.
When the 4th digit is entered, the system automatically exits the procedure.
2 Bops and 1 Beep will confirm the code has been entered successfully.
Key
Last
"ON"
digit
remote control buttons.
.
LED
OFF
.
Key
"OFF"
Key
LED
"OFF"
OFF
.
2nd digit
.
Key
LED
OFF
"OFF"
Bop
Key
"OFF"
Bop
Beep
PAGE 14
Advertisement
Table of Contents
