Canon CR-1 MARK II Operation Manual page 73

6.8 QA
Take the steps below to adjust the images.
1
Select the image.
Click the thumbnail image.
2
Display the QA (Quality Assurance) screen.
Click the QA icon.
3
Set the parameters.
If the parameters have been saved, click Parameter Set
from the list shown.
To set a new parameter, refer to the table below, and set it.
Parameter
Contrast
Brightness
Gamma
Hue (R)
Hue (G)
Hue (B)
Coordinate Hues
[Restore Defaults]
[Set as Default]
QA (Quality Assurance) screen
Any contrast level from -100 to 100 can be set.
Drag the slider or click
Any brightness level from -150 to 150 can be set.
Drag the slider or click
Any gamma level from 0.01 to 3.00 can be set.
Drag the slider or click
Any hue level from -100 to 100 can be set.
Drag the slider or click
When this is checked, as soon as the value of one of the hues is changed,
the values of the other two hues will also be changed so that the sum total
of the values will be zero.
When this is clicked, the current parameters are set to the default values
for the retinal camera mode of the adjusted images.
-65-
6. Main screen operations
, and click the name of the parameter set
Operation
or .
or .
or .
or .
Continued on the following page >>