Digital Camera Settings - Canon CR-1 MARK II Operation Manual

(13) Properties settings for the EOS digital camera
To prevent a wizard or menu opening when the EOS digital camera is connected, perform
the procedure below.
Windows Vista:
Windows XP:

2.2 Digital camera settings

(1) This software can only be used for digital cameras that were set by service personnel at
installation. For details on the supported digital camera and to change the digital camera
that is used, please contact a Canon representative or distributor.
(2) The settings may vary depending on the digital camera model.
(3) Do not make any improper changes to the digital camera settings. If the proper settings
are not made, the camera may be unable to take images. After changing the settings,
turn off the power switch to the digital camera to save the settings.
Setting example (EOS 50D)
For details on settings, see the EOS 50D Instruction Manual.
Note: Items listed as "Auto" in the Remarks column are automatically set by this software. Items
listed as "Required" show items where retinal images cannot be taken unless the settings
are made as indicated.
Items listed as "Recommended" are settings recommended by Canon. The customer
should act responsibly when making setting changes.
Basic settings
1) Open the Control Panel, and click Hardware and Sound, and click Play
CDs or other media automatically.
2) Select "Take no action" from the drop-down list for Canon EOS 50D.
Then, click [Save].
1) Select Scanners and Cameras in the Control Panel.
2) Right-click Canon EOS 50D, then open the Properties screen.
3) Click the Events tab and select "Take no action", then click [OK].
Item
Shooting mode
Drive mode
White balance
Shutter speed
ISO speed
Settings
M (Manual exposure)
(Single shooting)
(Flash)
60 (1/60 sec)
1600 • 3200 • 6400
-5-
2. Notes on use
Remarks
Auto
Auto
Auto
Auto
Auto
Continued on the following page >>