Canon imageRUNNER C2550 Network Manual page 160

Cause 7
Remedy
Unable to Print from a NetWare Network
Cause 1
Remedy
Cause 2
Remedy
7
NOTE
Your computer may not be able to recognize the machine, even though the IP address
settings are appropriate. This problem may be resolved by delaying the startup of
network communications for the machine. (See "Startup Time Settings," on p. 3-42.)
Cause 3
Remedy
Cause 4
7-6
Printing Problems and Remedies
An error message is displayed on the touch panel display of the machine.
After confirming the error message, see Chapter 8, "Troubleshooting," in the
Reference Guide and perform the necessary operations according to the error
message displayed.
The machine and cable are not properly connected.
Turn OFF the machine's power switches, check that the machine is connected
to the network using the proper cable, and then turn them ON. (See
"Connecting the Machine to a Computer or Network," on p. 2-3.)
The NetWare network is not properly set up.
Check the following:
•
Confirm that the NetWare file server is running.
•
Confirm that there is sufficient disk space on the NetWare file server. Large
files cannot be printed if there is insufficient disk space.
•
Start NWADMIN or PCONSOLE, and then confirm that the print queue is set
up properly and is active.
•
Confirm that the network settings of the machine are correctly set. (See
"Protocol Settings," on p. 4-8.) Check the following in particular:
- A valid frame type is selected from the Frame Type drop-down list.
- [Print Server] and [Printer Number] are correctly specified.
The computer that is printing is not properly set up.
Check the following:
•
Confirm that the proper printer driver is installed. If you are printing from
Windows, each computer must have a printer driver installed.
•
For instructions on how to install printer drivers, see the Driver Guide.
•
Confirm that the correct printer is set as the output destination for the
computer that is printing. Confirm the output destination in [Printer] in [Control
Panel].
If you are using an NDS PServer or Bindery PServer and the print server has a
password setting, the machine's password setting is incorrect.