Stiga Park Series Workshop Manual page 71

Edition Manual
2014-09-20 Workshop Manual, GGP Park 4 Hydraulic system
4. Place one container under the rear axle and
one under the front axle.
5. Open the oil reservoir by removing the
cover.
Only a 3/8" square drive may be used
for the plug. Other tools will damage
the plug.
6. Remove the plug from the rear axle. Clean
the hole and use a 3/8" square drive. If the
machine is equipped with filter, remove the
filter and allow the oil in the rear axle and
reservoir to run out. See the figure.
7. Remove 2 drain plugs from the front axle.
Use a 12 mm socket. Allow the oil in the
front axle and pipes to run out.
See the figure.
8. Check that the gaskets on the drain plugs of
the front axle are intact. See the figure.
Reinstall the plugs.
Tightening torque: 15-17 Nm.
The plug will be damaged if it is tight-
ened more to than 5 Nm.
9. Check that the gasket on the plug (V) of the
rear axle is intact. Reinstall the (filter) and
plug in the rear axle.
Tighten the plug to 5 Nm.
10.Draw out the oil from the deeper section of
the reservoir using an oil extractor. See the
figure.
11.Dispose of the oil according to local regula-
tions.
Chapter Page
28