Stiga Park Series Workshop Manual page 100

Edition Manual
2014-09-23 Workshop Manual, GGP Park 7 Electrical System
7.2 Trouble Shooting
Warning!
Do not wear rings, metallic bracelet, chain round the neck or similar metal
objects when working with the electrical system. It can cause short-circuit,
burns and fire.
This section describes the trouble shooting procedures in absence of an electrical function.
It also describes the correction measures in each actual case. When following the trouble
shooting tables, it is provided that the following states are fulfilled:
• All fuses are checked and, if necessary replaced.
• The battery shall be charged.
• All harnesses are OK.
• All connectors are OK.
• The requirements for the actual measure shall be fulfilled. E.g. if it is advised to perform a
start attempt, the operator shall sit down on the seat, press the brake pedal and the
power take off shall be in disengaged position.
When following the trouble shooting tables, it is in normal cases assumed that conductors
and connectors to conductors are OK. However, in some cases, after a long period of use
or in case of mechanical damages, the cables at the articulating point can be damaged.
The circuit diagrams are presented after the tables.
Circuit diagrams; From models 2015 there are also ISO-rules implemented in the electrical
diagrams, where this occours additional diagrams, marked "20015" included.
For trouble shooting, first find the actual machine in the list at the next page and then go to
the page with the trouble shooting tables for that machine.
The trouble shooting tables below do not need any complicated measurements, checks or
other logic steps to isolate the fault. The actions to be taken are listed with the most
probable fault first.
That means, if not the first action helps, then try with the next one. Continue thus until the
fault is repaired.
Faults related to the safety system are located first in the tables and marked with
Chapter Page
3
.