Stiga Park Series Workshop Manual page 112

Edition Manual
2014-09-23 Workshop Manual, GGP Park 7 Electrical System
Valid for (
Art. Number)
13-6180-XX 13-6181-34
Fault
The engine can be started
with the mower deck activated.
The engine can be started
without the brake pedal
pressed.
The engine does not stop
when the operator leaves the
seat and the mover deck is
activated.
The engine does not stop.
The starter does not rotate and
there is no "click" heard at the
start attempt.
The engine can be started
without the operator in the seat,
brake pedal pressed and deck
not activated.
The starter does not rotate and
there is a "click" heard at the
start attempt.
The starter rotate, but the
engine does not start.
The battery runs repeatedly
empty.
Electric mower deck
adjustment does not work
Chapter
1005-0081
- -
Cause/Alternative
The engine can be stopped with
the ignition key.
The engine can not be stopped
with the ignition key.
Fault in the safety circuits.
Faulty start engine or start relay
The light does not work.
The light works.
A connected voltmeter to the
battery shows a higher voltage at
high speed than if the engine not is
running.
No voltage different.
Works in one direction only.
Works not in any direction.
-
Action
Adjust or replace the mover deck switch.
Replace/adjust the pedal switch.
Adjust or replace the grey seat switch.
Replace the ignition switch.
Replace the shut off valve.
1. Adjust/replace the pedal switch.
2. Adjust/replace the black seat switch.
3. Adjust/replace the mover deck switch.
4. Replace the ignition switch
Adjust/replace the black seat switch.
1. Check cable connections.
2. Replace the start relay.
3. Replace the start engine
Replace the ignition switch.
1. Check the fuel supply.
2. Check the engine according to
the engine manual.
3. Adjust/replace the seat switch.
4. Replace the shut off valve.
Replace the battery.
Replace/repair the charging unit in the
engine. See the engine manual.
Replace the height adjustmen switch.
1. Check the contact.
2. Check the cables.
3. Check the motor by connecting an
additional battery to the deck cable.
4. Replace the switch.
Page
15