Stiga Park Series Workshop Manual page 69

Edition Manual
2014-09-20 Workshop Manual, GGP Park 4 Hydraulic system
Filling
1. Check that the gaskets on the 4 drainage
plugs are intact. Reinstall the plugs. Tighten-
ing torque: 15-17 Nm.
2. Machines with externa hydraulic:
Moisten the new filter's gasket with oil and
install the filter.
3. Fill the oil reservoir with the new oil.
4. Check that the clutch release lever (R) is in
the outer position (drive position).
If the engine is to be run indoors, an
exhaust extraction device must be
connected to the engine's exhaust
pipe.
5. Prepare a suitable vessel with the new oil.
NOTE! The oil is sucked into the system
very quickly. The reservoir must always
be kept topped up. Under no circum-
stances may air be sucked in.
6. Fill the oil reservoir with new oil.
7. Start the engine and allow it to idle. Gradu-
ally top up the oil in the reservoir so that the
level constantly reaches the mark.
8. Reinstall the oil filler cap and close the
engine casing.
9. Reset the drive shafts' valves in accordance
with the figure.
10.Drive the machine 8-10 metres forwards
and 8-10 metres backwards. If the machine
has hydraulic power assisted steering, apply
full steering lock at the same time.
11.If the machine has a hydraulic implement
lifter, raise and lower the lifter 3-4 times.
12.Adjust the oil level in the reservoir.
Chapter
R
Page
26