Fitting The Harness - Stihl FS 111 Instruction Manual

13 Fitting the Harness

12.1 Preparations
► Before fueling, clean the filler cap and the area
around it to ensure that no dirt falls into the
tank.
► Position the machine so that the tank cap
faces up.
12.2 Opening the Tank Cap
► Turn the cap counterclockwise until it can be
removed from the tank opening.
► Remove the tank cap.
12.3 Filling Up with Fuel
Take care not to spill fuel while fueling and do
not overfill the tank.
STIHL recommends you use the STIHL filler noz‐
zle for fuel (special accessory).
► Fill up with fuel.
12.4 Closing the Tank Cap
► Place the cap in the opening.
0458-430-0121-B
► Turn the cap clockwise as far as stop and
tighten it down as firmly as possible by hand.
13 Fitting the Harness
The type and style of the harness/shoulder strap
depend on the market.
The use of the shoulder strap is described in the
chapter on "Approved Combinations of Cutting
Attachment, Deflector, Handle and Harness".
13.1 Shoulder Strap
► Put on the shoulder strap (1).
► Adjust the length of the strap so that the cara‐
biner (2) is about a hand's width below your
right hip.
► Balance the machine – see "Balancing the
Machine".
English
1
2
23