Stihl FS 111 Instruction Manual page 21

10 Mounting the Cutting Attachment
10.8 Mounting Metal Cutting Attach‐
ments
Keep the leaflet and packaging of the metal cut‐
ting attachment in a safe place.
WARNING
Wear protective gloves to reduce the risk of
direct contact with the sharp cutting edges.
Mount only one metal cutting attachment.
Check direction of rotation of cutting attachment
1
4
7
Cutting attachments 2, 4, 5 and 6 may be moun‐
ted either way round – they must be turned over
regularly to help avoid one-sided wear.
The cutting edges of cutting attachments 1, 3, 7
and 8 must point clockwise.
Direction of rotation is indicated by an arrow on
the inside of the deflector.
0458-430-0121-B
3
2
6
5
8
► Fit the thrust plate (9).
► Place the cutting attachment (8) on the thrust
plate (9).
Collar (see arrow) must engage the cutting
attachment's mounting hole.
Securing the cutting attachment
► Fit the rider plate (10).
► Block the shaft (11) with the stop pin (12).
► Use the combination wrench (14) to screw the
mounting nut (13) on to the output shaft coun‐
terclockwise and tighten it down firmly.
WARNING
There is a risk of injury if the cutting attachment
works loose. If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
10.9 Removing the Metal Cutting
Attachment
WARNING
Wear protective gloves to reduce the risk of
direct contact with the sharp cutting edges.
► Block the shaft (11) with the stop pin (12).
► Unscrew the mounting nut (13) clockwise.
English
14
13
10
11
9
12
8
21