Stihl FS 111 Instruction Manual page 20

English
10.3 Blocking the Shaft
7
6
The output shaft (2) must be blocked with the
stop pin (6) or screwdriver (6) to mount or
remove cutting attachments. These parts come
standard with the machine or are available as
special accessories.
► Insert the stop pin (6) or screwdriver (6) in the
hole (7) in the gearbox as far as stop – and
apply slight pressure.
► Rotate shaft, nut or cutting attachment until
the stop pin slips into position and blocks the
shaft.
10.4 Removing the Mounting Hard‐
ware
► Block the shaft (5) with the stop pin (1).
► Use the combination wrench (2) to loosen and
remove the nut (3) clockwise (left-hand
thread).
20
2
6
2
3
4
5
6
1
10 Mounting the Cutting Attachment
► Take the rider plate (4) off the shaft (5). Do not
remove the thrust plate (6).
10.5 Mounting the Cutting Attach‐
ment
WARNING
Risk of injury from thrown objects and contact
with the cutting attachment. Use a deflector that
matches the cutting attachment – see "Mounting
the Deflector".
10.6 Fitting Mowing Head with
Screw Mounting
Keep the instruction leaflet for the mowing head
in a safe place.
► Fit the thrust plate (1).
► Screw the mowing head (3) counterclockwise
on to the shaft (4) as far as stop.
► Block the shaft (4) with the stop pin (2).
► Tighten down the mowing head (3) firmly.
NOTICE
Remove the tool used to block the shaft.
10.7 Remove the mowing head.
► Block the shaft (4) with the stop pin (2).
► Unscrew and remove the mowing head (3)
clockwise.
3
4
1
2
0458-430-0121-B