Mounting The Cutting Attachment - Stihl FS 111 Instruction Manual

10 Mounting the Cutting Attachment

9.6 Mounting the Limit Stop
6
WARNING
Risk of injury from thrown objects and contact
with the cutting attachment. Always fit the limit
stop (6) when you use a circular saw blade.
► Position the limit stop (6) on the gearbox
flange.
► Insert the screws (7) and tighten them down
firmly.
10 Mounting the Cutting
Attachment
10.1 Placing power tool on the
ground
► Shut off the engine.
► Lay your power tool on its back so that the cut‐
ting attachment mounting face is pointing up.
10.2 Mounting Hardware for Cutting
Attachments
The mounting hardware supplied depends on the
cutting attachment that comes as original equip‐
ment with the new machine.
10.2.1 Machine supplied with mounting hard‐
ware
Mowing heads and metal cutting attachments
may be mounted.
0458-430-0121-B
7
Depending on the cutting attachment, it may be
necessary to use the nut (3) and rider plate (2).
The thrust plate (1) must be used with all cutting
attachments.
These parts are included in a kit supplied with
the machine and are also available as special
accessories.
10.2.2
Only mowing heads may be used which mount
directly to the shaft (2).
2
Machine supplied without mounting
hardware
2
English
3
1
19