Mounting The Cutting Attachment - Stihl HSE 61 Manual

4.1.2 Mounting the cutting
attachment
Up to serial number 9 72 393 577
4
1
3
: Place the cutting attachment (1)
on the gear housing (2).
– Engage the lower blade on the
lower connecting rod (3).
: Line up holes in cutting
attachment with holes in gear
housing (2) and insert the screws
(4) but do not finally tighten yet.
2
1
: Engage the upper blade (1) on
the upper connecting rod (2).
16
4
2
: Tighten down the screws (1)
firmly (2.9 Nm).
: Check that the pin (1) is fitted in
the cover (2). If the pin (1) is not
in the cover (2), fit it as shown in
the illustration.
b 4.1.1
From serial number 9 72 393 578
1
1
: Place the cutting attachment (1)
– Engage the lower blade on the
: Line up holes in cutting
1
2
: Engage the upper blade (1) on
on the gear housing (2).
lower connecting rod (3).
attachment with holes in gear
housing (2) and insert the screw
(4) but do not finally tighten yet.
2
1
the upper connecting rod (2).
HSE 61, HSE 71, HSE 81