Unpacking And Installation Instructions For Stand-Alone Version - Kodak HEALTH SCIENCES MINILOADER 2 Plus Stand-alone Installation Instructions Manual

II 3239

UNPACKING AND INSTALLATION INSTRUCTIONS FOR STAND-ALONE VERSION.

1. Remove the BANDING from the PACKING CASE then lift the CARTON off the MINILOADER
PALETTE.
2. Remove the MAGAZINES from the top of the MINILOADER and unpack them.
The case should contain:-
PARTNo. QUANT
xxxxxxxx
30023169
30023168
30026197
30026239
30026240
30025844
30025845
30025846
30025847
30025849
30026265
3. Remove the LID and lift the MINILOADER onto a suitable STAND or BENCH. See figure 18 for
detailsof the holes required in the STAND or BENCH to secure the MINILOADER. See APPENDIX
"A" for drawings of suitable STANDS
!! CAUTION TWO PEOPLE
Figure 18
660 mm
© Kodak Ltd.
DESCRIPTION
1 MINILOADER 2 PLUS STAND-ALONE VERSION
1 SUPPLY MAGAZINE 18x24 CM
1 SUPPLY MAGAZINE 24x30 CM
1 SUPPLY MAGAZINE 8x10 INCH
1 RECEIVING MAGAZINE 18x24 CM
1 RECEIVING MAGAZINE 24x30 CM / MIXED SIZES
2 KEYS FOR INTERLOCK OVERRIDE (INSIDE MINILOADER)
4 LARGE FLAT WASHERS, INTERNAL DIAMETER 8 MM
4 SET SCREW, HEXAGON HEAD, M8 x 40 MM
4 SET SCREW, HEXAGON HEAD, M8 x 60 MM
1 CAN OF TOUCH-UP PAINT
1 PIN 6 x 35 MM (INSIDE MINILOADER, PACKED WITH THE KEYS)
ARE
Drill 4 HOLES 10 mm
diameter in the
STAND or BENCH.
Feed
end.
INSTALLATION INSTRUCTIONS
REQUIRED TO LIFT THE MINILOADER !!
690 mm centres
Receiv-
ing
end
770 mm
Page II-16
580 mm
centres
December 1992