Konica Minolta CM-36dGV Instruction Manual page 32

Hide thumbs Also See for CM-36dGV:

Table of Contents

• Perform measurement when the specimen or the inside and outside of the container containing the specimen

are free of scratches, fingerprints, and other dirt. If the measurement surface is grasped with a hand,

fingerprints will be left on it. Hold the specimen at a part which is not the measurement surface.

• If there are bubbles on the inside of the container containing the specimen, accurate measurement will not be

possible. Remove the bubbles before performing measurement. (Bubbles may form spontaneously when a

specimen is left in the container.)

• If there is condensation or other water droplets on the specimen or the container containing the specimen,

accurate measurement will not be possible.

• When measuring a liquid which contains minute particles, accuracy will be unstable due to precipitation of the

particles.

3 Close the transmittance specimen chamber cover.

4 Use the optional SpectraMagic NX (CM-S100w) color

data software and perform measurement. When remote

measurement mode is selected, measurement can

also be performed using the measurement key on the

instrument status panel.

Haze Measurement

When the white calibration plate is installed at the specimen measuring port for reflectance measurement, the

measurement type is di: 0°. When the zero calibration box is installed instead of the white calibration plate, the

measurement type is de: 0°.

Although the illumination/viewing system does not completely match the definition of haze (ASTM D 1003), it can

be used as a relative value for management.

When using the optional SpectraMagic NX (CM-S100w) color data software for haze measurement, haze is

calculated from these 2 measurements.

Table of Contents