Preparation; Installing The Receptor Head; Removing The Receptor Head; Selecting Measuring Units - Konica Minolta T-10A Instruction Manual

Preparation

Installing the Receptor Head

▼For T-10MA

Removing the Receptor Head

▼For T-10MA

Selecting measuring units

The Konica Minolta llluminance Meter allows you to take readings
in either Lux (lx.) or Foot-candle (fcd) units.

Attaching the Cap

■ For T-10A
8
1
Attach the receptor head (Mini receptor head in the case of
T-10MA) to the main body.
1
Hold down the receptor head remove button, then pull out
the receptor head (Mini receptor head in the case of T-10MA)
from the main body.
z Always set the power switch to the OFF position (the ""side) before
attaching or removing the receptor head.
Attaching or removing the head while the
power is ON may generate an error.
1
Set the power switch to " " (OFF), and pull the battery cover
while pressing it down slightly.
2
Remove two AA-size batteries, if it exits.
3
Set the measuring-unit selector to the desired position
(lx. or fcd).
4
Pull back those batteries and battery cover.
When attaching the strap to the main body, attach the
cap to the strap as shown below.
1
Pass the strap through the string extended
from the cap, then attach the strap to the
main body.