Troubleshooting - KTM 1290 SUPER ADVENTURE R 2021 Owner's Manual

22 TROUBLESHOOTING

Faults
No response if the RACE ON
button is pressed
RACE ON indicator light
flashes twice
RACE-ON indicator lamp
flashes three times
RACE-ON indicator lamp
flashes four times
RACE-ON indicator lamp
flashes five times
RACE ON indicator light
flashes six times
RACE ON indicator light
flashes seven times
The combination instrument
shows nothing on the display
Engine does not rotate if the
start button/emergency OFF
switch is pressed into the lower
position
154
The RACE ON indicator light
flashing. These are indicated up to five seconds after the RACE
ON button is actuated.
Info
Blink codes referring to KTM RACE ON are only displayed
once and not repeated.
E02045-10
Possible cause
RACE-ON button faulty
No response signal from the
RACE ON key
12-V battery discharged
Steering lock bolt locked or
tense
RACE ON antenna faulty
Electronic fault
Anti-relay attack mode on
RACE ON key could not be
activated.
Fuse 1 blown
Main fuse burned out
12-V battery discharged
Operating error
12-V battery discharged
1
can indicate malfunctions by
Action
–
Check the RACE-ON button for dam-
age.
–
Check the cable and the plug of the
RACE-ON button for damage.
–
Ensure that the RACE ON key anti-
relay attack mode has been deacti-
vated.
–
Ensure that the RACE ON key is in
range.
–
Remove other electronic devices from
the vicinity of the RACE-ON antenna.
–
Check the battery compartment in the
RACE-ON key for correct locking.
–
Check the battery compartment of the
RACE-ON key for corrosion.
–
Change the RACE-ON key battery.
( p. 135)
–
Hold RACE ON chip or RACE ON
key directly to the vehicle antenna
( p. 21).
–
Charge the 12-V battery.
–
Check the open-circuit current.
–
Move handlebar slightly.
–
Check the RACE-ON antenna for dam-
age.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Switch the ignition on and off again
while the RACE ON key is within range
of the vehicle.
–
Change the fuses in the fuse box.
( p. 137)
–
Change the main fuse. (
–
Charge the 12-V battery.
–
Check the open-circuit current.
–
Carry out start procedure. (
–
Charge the 12-V battery.
–
Check the open-circuit current.
( p. 133)
p. 136)
( p. 133)
p. 72)
( p. 133)