Main work
–
Check the rear hub damping rubber pieces.
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal ring
the spacer.
Long-life grease (
–
Insert a spacer.
–
Clean and grease the thread of the wheel spindle and nut.
S01639-10
Long-life grease (
–
Mount the damping rubber pieces and rear sprocket carrier on
the rear wheel.
–
Place the rear wheel in the link fork and engage the brake disc
in the brake caliper.
–
Mount wheel spindle
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
E02389-10
–
Push wheel spindle in all the way and mount chain
4
adjuster
and nut
Info
Mount chain adjusters
tion.
–
Make sure that the chain adjusters are fitted correctly on the
adjusting screws.
Guideline
In order for the rear wheel to be correctly aligned, the mark-
ings on the left and right chain adjusters must be in the
same position relative to reference markings
–
5
Tighten nut
Guideline
Nut, rear wheel
spindle
E02390-10
1
and contact surface
p. 172)
p. 172)
2
, but do not push it in all the way.
5
.
3
4
and
in the same posi-
.
M25x1.5
90 Nm (66.4 lbf ft)
WHEELS, TIRES 15
(
p. 126)
A
of
B
.
Thread greased
125