KTM 1290 SUPER ADVENTURE R 2021 Owner's Manual page 78

10 RIDING INSTRUCTIONS
Note
Engine damage Unfiltered intake air has a negative effect on the service life of the engine.
Dust and dirt will enter the engine without an air filter.
–
Only operate the vehicle if it is equipped with an air filter.
Note
Engine failure Overheating damages the engine.
–
If the coolant temperature warning is displayed, stop immediately and take care not to endanger yourself or
other traffic participants in the process.
–
Allow the engine and cooling system to cool down.
–
Check and, if necessary, correct the coolant level on the cooling system while it is in a cooled state.
Note
Transmission damage Incorrect use of the quickshifter+ will damage the transmission.
The quickshifter+ can only be used if the function is enabled in the combination instrument.
The quickshifter+ is not active if you pull the clutch lever.
–
Only use the quickshifter+ in the permitted speed range shown.
76
Warning
Danger of accidents A fall can damage the vehicle more seriously than it may first appear.
–
Check the vehicle after a fall as you do when preparing for use.
Info
If you hear unusual noises while riding, stop immediately, switch off the engine, and contact an autho-
rized KTM workshop.
402299-11
–
Shift into a higher gear when conditions allow (incline, road
situation, etc.).
–
Release the throttle while simultaneously pulling the clutch
lever, shift into the next gear, release the clutch lever, and
open the throttle.
Info
The gear positions can be seen in the figure. The idle
position is between the first and second gears. First
gear is used for starting off or for steep inclines.
–
After reaching maximum speed by fully opening the throttle
grip, turn the throttle back so it is ¾ open. This will barely
reduce the speed, but fuel consumption will be considerably
lower.
–
Accelerate only up to a speed suitable for the road surface and
weather conditions. Particularly in bends, do not shift, and
accelerate very carefully.
–
Brake if necessary and close the throttle at the same time in
order to shift down.
–
Pull clutch lever and shift into a lower gear, release the clutch
lever slowly, and open the throttle or shift again.
–
If the engine stalls (e.g. at an intersection), just pull the clutch
lever and press the start button. The transmission must not be
shifted into neutral.