Steering Lock (Antenna); Immobilizer; Race On Key - KTM 1290 SUPER ADVENTURE R 2021 Owner's Manual

6.16

Steering lock (antenna)

6.17

Immobilizer

6.18

RACE ON key

On this vehicle, the ignition and steering lock is replaced by a
remote key with transponder (RACE ON key (
In order to activate the steering lock, the handlebar must be
turned fully to the left.
The steering is locked and unlocked electromechanically via the
RACE-ON button
If the battery voltage of the RACE ON key is too low, hold the
RACE ON key or the RACE ON chip in the
motorcycle and repeat starting.
E02330-10
Info
As soon as the engine has been started, safely stow away
the RACE ON key or the RACE ON chip again.
Possible states
Ignition off, steering locked – In this operating mode, the
•
ignition circuit is interrupted and the steering locked.
Ignition off, steering unlocked – In this operating mode, the
•
ignition circuit is interrupted and the steering unlocked.
Ignition on, steering unlocked – In this operating mode, the
•
ignition circuit is closed and the steering unlocked.
The electronic immobilizer secures the vehicle against unautho-
rized use.
The immobilizer is activated and the engine electronics are locked
as soon as the ignition is switched off via the RACE-ON button
( p. 20).
The RACE ON indicator light
flashing.
If the optional alarm system is installed, the RACE ON indicator
1
light flashes red when the alarm system is switched on.
E02045-10
On this vehicle, the RACE ON key
the conventional ignition key.
If the battery voltage of the RACE ON key is too low, the vehi-
cle can be started by holding the RACE ON key directly to the
vehicle antenna (
The RACE ON chip
RACE ON key is not available.
Like the RACE ON key, the RACE ON chip can be used to start
the vehicle by holding the chip directly to the vehicle antenna
E02206-10 ( p. 21).
Info
The ignition keys contain electronic components. Always
maintain a distance of several centimeters to other devices
with electronic components.
p. 21)).
( p. 20).
A
area on the
1
can indicate malfunctions by
1 performs all the functions of
p. 21).
2
is only intended for situations in which the
CONTROLS 6
21