KTM 1290 SUPER ADVENTURE R 2021 Owner's Manual page 157

Faults
Engine does not rotate if the
start button/emergency OFF
switch is pressed into the lower
position
Engine turns only if the clutch
lever is drawn
Engine turns although a gear is
engaged
Engine turns but does not start
Engine dies during the trip
Malfunction indicator lamp
lights up
The ABS warning lamp lights
up
High oil consumption
12-V battery discharged
Possible cause
Faulty safety starting system
Electronic fault
The vehicle is in gear
Faulty safety starting system
Faulty safety starting system
Quick release coupling not
joined
Malfunction in the electronic
fuel injection
Fuel quality is insufficient
Lack of fuel
Malfunction in the electronic
fuel injection
Malfunction in the electronic
fuel injection
ABS fuse blown
Wheel speeds of front and rear
wheels differ greatly
Malfunction in ABS
Engine oil level too high
Engine oil too thin (low viscos-
ity)
An electrical power consumer is
connected to the socket/ACC1.
The hazard warning flasher is
switched on
The 12-V battery is not being
charged by the alternator
Ignition was not switched off
when vehicle was parked
TROUBLESHOOTING 22
Action
–
Read out the fault memory using the
KTM diagnostics tool.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Shift the transmission into neutral.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Join quick release coupling.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Add suitable fuel.
–
Refuel. ( p. 80)
–
Read out the fault memory using the
KTM diagnostics tool.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Change the fuses in the fuse box.
( p. 137)
–
Stop, switch off the ignition, start
again.
–
Read out the fault memory using the
KTM diagnostics tool.
–
Check the engine oil level. (
–
Change the engine oil and the oil filter,
clean the oil screens. (
–
Disconnect the electrical power con-
sumer from the socket/ACC1.
–
Charge the 12-V battery.
–
Switch off the hazard warning flasher.
–
Charge the 12-V battery.
–
Check the charging voltage.
–
Charge the 12-V battery.
p. 145)
p. 145)
( p. 133)
( p. 133)
( p. 133)
155