KTM 1290 SUPER ADVENTURE R 2021 Owner's Manual page 19

Warning
Danger of accidents The cruise control system function is not suitable for all riding situations.
The selected target speed will not be reached, if the engine power is not sufficient for a gradient.
The selected target speed will be exceeded if the engine braking effect is not sufficient on an incline.
–
Do not use the cruise control systems function on winding roads.
–
Do not use the cruise control systems on slippery road surfaces (e.g. rain, ice or snow), where there is
poor visibility or on unpaved surfaces (e.g. sand, stones or gravel).
–
Do not use the cruise control systems function if the traffic does not permit a constant speed.
Functions of cruise control:
–
After activation of the cruise control system function, the throttle grip can be turned back to the basic posi-
tion. The selected speed will be maintained.
–
If no cruise speed has yet been saved, this can be saved using the +RES button.
–
If the target speed is exceeded for less than 10 seconds by turning the throttle grip, the cruise control system
remains activated.
–
If the cruise speed differs from the current speed by more than 10 km/h or 10 mph, e.g. when passing
another vehicle, the current speed is stored as the cruise speed by pressing the ‑SET button briefly.
–
If there is a steep downhill slope and the engine braking effect is not sufficient to maintain the set cruise
speed, the system brakes actively.
–
If the set cruise speed is significantly below the current speed, the system brakes actively in order to reach
the cruise speed.
–
The speed is reduced as the lean angle increases.
The cruise control function is deactivated when one of the following events occurs (switch-off conditions):
–
Operating the handbrake lever.
–
Operating the rear brake lever.
–
Operating the clutch lever for more than 2.5 seconds.
–
Closing the throttle beyond the basic position.
–
Slip at the rear wheel or the front wheel lifting and thus associated regulation of the motorcycle traction con-
trol (MTC) for longer than 1 second.
–
Control of ABS for more than 1 second.
–
A malfunction occurring, which impairs the cruise control system function.
–
Exceeding the cruise speed for more than 10 seconds when passing a vehicle.
–
Lean angles exceeding 41°.
–
Engine speed below 1,500 rpm.
–
Engaging the first gear or shifting transmission to the neutral position.
–
Motorcycle traction control (MTC) is switched off.
–
ABS mode Offroad is activated.
The cruise control can only be activated if the following conditions are met (switching conditions):
–
Motorcycle traction control (MTC) is activated.
–
No strong acceleration.
–
Do not exceed a lean angle greater than 41°.
–
2nd, 3rd, 4th, 5th or 6th gear is engaged.
–
Vehicle speed between 30 and 200 km/h or between 20 and 125 mph.
–
ABS mode Road is active.
CONTROLS 6
17