Setup
7.10 Performing a test run
When setup is complete, perform a test run to check the functionality of
the machine.
To perform a sewing test:
1. Switch off the machine.
2. Thread the needle thread ( p. 22).
3. Insert the bobbin ( p. 26).
4. Switch on the machine.
The control is initialized.
5. Press the pedal forwards.
The reference run starts.
Information
The reference run is necessary in order to obtain a defined starting
position of the transport carriage.
Pressing the pedal forwards triggers the different steps of the insertion
procedure one after another and then starts the sewing process.
Operating Instructions 911-210-10 - 00.0 - 06/2020
The transport carriage moves to the reference position.
109