Table of Contents
Advertisement
Information
The remaining thread monitor (MP 1, Optionale Einrichtungen (Optional
equipment)) and the bobbin counter (MP 6) can be activated simultaneously.
The display shows the two options as follows:
Fig. 47: Remaining thread monitor and bobbin counter
(1) - Display - remaining thread monitor:
72
Symbol
Meaning
Pedal mode
The following options are available:
• Mode 1: The current position of the pedal is evaluated
• Mode 2 (Def.): The pedal must be returned to the initial position after
every actuation before a new actuation is recognized
• Mode 3: The current position of the pedal is evaluated. The quick-start
mode is also enabled (see Load mode ( p. 62)). The machine must
be switched off and on in order to activate the quick-start mode.
• Push button: In push button mode one sensor is used only for controlling
the clamp motion (up and down). The other sensor is used for starting the
sewing process.
Barcode mode
The following options are available:
• Manual: Machine checks whether the inserted clamp matches the
entered seam program. If the clamp is correct, the machine is ready for
sewing. If the clamp is incorrect, an error message will be displayed, and
the clamp will have to be replaced.
• Automatic: The machine looks for the seam program that matches the
inserted clamp. The machine is ready for sewing once the seam program
has been selected.
①
Remaining thread monitor active:
R shown
Remaining thread monitor inactive:
R hidden
②
(2) - Display - bobbin counter:
Bobbin counter active: Number black
Bobbin counter inactive: Number
grayed-out
Operating Instructions 911-210-10 - 00.0 - 06/2020
Programming
Advertisement
Table of Contents
