DURKOPP ADLER 911-210-3020-10 Operating Instructions Manual page 120

Code
3123
3210
3215
3220
3500
3501
3502
3721
3722
4201
5301
6551
6554
6651
6653
6751
6761
6952
Communication
7801
8151
8156
8159
8154
8252
8257
8258
8256
8254
118
Description
Oil sensor active
Thread broken
Bobbin empty (remaining thread
counter)
Bobbin empty (remaining thread
counter)
Error in calculating the contour data
Target position of the XY clamps
outside the motion limits
Target position of the XY clamps within
the "forbidden areas"
Internal error
Internal CF card defective
Program cannot be sewn
Error in machine head position/AD
converter/process error
Internal error
Stepper motor driver error
Internal error
Control panel interface communication
• Cable disturbance
• Cable
IDMA error
• Disturbance
• Control defective
8152 IDMA error
• Internal error
ADSP Boot/Xilinx Boot/ Boot error
Disturbance
Troubleshooting
Troubleshooting
Top off the oil
Re-thread the thread
Insert full bobbin
Insert full bobbin
• Reload the contour data
• Check the contour data
Adjust the contour data
Adjust the contour data
• Switch off and on the machine
• Software update
• Notify DA Service
• Switch off and on the machine
• Retrofit/replace control
Copy program to DAC
• Switch off and on the machine
• Software update
• Notify DA Service
• Switch off and on the machine
• Software update
• Notify DA Service
• Switch off and on the machine
• Software update
• Notify DA Service
• Switch off and on the machine
• Replace control
• Switch off and on the machine
• Software update
• Notify DA Service
• Switch off and on the machine
Operating Instructions 911-210-10 - 00.0 - 06/2020