Non-Automatic Firmware Activation In Linux - Western Digital Ultrastar Data60 User Manual

User Guide
Step 7 : Verify the installation is correct by repeating the sg_scan -i again.
Step 8 : Ensure multi-pathing can see all of the expected drives.
a. Execute the following command to verify that there are two paths to each drive:
5.1.4 Non-Automatic Firmware Activation in Linux
Step 1 : Ensure multi-pathing can see all of the expected drives.
a. Execute the following command to verify that there are two paths to each drive:
Step 2 : Locate the <dev> device name from the sg_scan -i.
Step 3 : Execute the following command to upgrade the enclosure firmware using sg_ses_microcode.
a. Issue the following command:
Step 4 : Press Enter.
The firmware begins loading onto the IOMs. The upgrade can take up to 20 minutes to
complete.
Note: The firmware update is downloaded to both IOMs at the same
time.
multipath -ll | grep -i "active ready running" -c
multipath -ll | grep -i "active ready running" -c
sg_ses_microcode <dev> -m 0xe -N -b 4096 -I <filename> -vv
Important: Due to the firmware image being a .tar.gz file, the enclosure has to
unpack and load the firmware onto the respective ICs which may take up to 15
minutes. Once the sg_ses_microcode command is issued wait 20 minutes to
ensure the enclosure has time to perform this process. To check the status of
this process, use the Redfish out-of-band management to make a GET request
to the following target:
curl -G -k -u admin:admin -H "Content-type: application/
json" https://<ip address>/redfish/v1/UpdateService/Actions/
UpdateService.SimpleUpdate/Status
Note: Execute the command until you see the following result:
{"ErrorCode":0,"StatusCode":2,"Description":"FW
update completed. Waiting for
activation.","EstimatedRemainingMinutes":0}
5. System Management
5.1 Firmware Upgrade
169