Western Digital Ultrastar Data60 User Manual page 161
Hide thumbs
Also See for Ultrastar Data60:
- User manual (260 pages) ,
- Installation manual (78 pages) ,
- Manual (57 pages)
Table of Contents
Advertisement
User Guide
a. Check that the crossbar is fully secured to the CMA mounting bracket by pulling on the
bar to ensure it does not move.
Step 46 : Cable the CMA(s).
a. Unlatch the elbow side of the arm(s) by pressing the blue button labeled "push," and then
swing the arm(s) open.
b. Gather the SAS, power, and Ethernet cables for installation. Before cabling, note the
following routing patterns for best results:
Figure 177: Tightening the Thumbscrew
Note: Route the cables supported by the lower arm to IOM A (left
hand side looking at the rear). Second, route the cables supported
by the upper arm to IOM B (right hand side looking at the rear) in
a "criss-cross" pattern. See the
Routing (page 157)
4.9 Chassis Replacement
Special Considerations for Cable
for more information.
4. Part Replacement
151
Advertisement
Table of Contents
