Western Digital Ultrastar Data60 User Manual page 114

User Guide
b. Press the release clip and press lightly toward the rear of the rack to compress the rail
clear of the rack post.
c. Let go of the rail and move to the rear of the rack.
d. Support the rail with one hand and press the release button with the other to free the rail
from the rack and remove it.
Step 18 : Gather the replacement rails and prepare to install them.
Step 19 : Remove the inner rail that is nested inside the rack rails.
a. Start by sliding the inner rail out of the outer/rack rail until the safety latch engages and
the inner rail will not extend further. It will only slide one way.
b. Press on the safety latch release spring located on the side of the rail and slide the inner
rail out the rest of the way.
Figure 106: Rear Rail Latch Release Button
Note: There are Right and Left rails and they must be installed as a set.
Each inner rail will read "R" for the right or "L" for the left embossed on the
inside. Each outer rail will read "R-Front" for the right or "L-Front" for the
left. Right and Left refer to when you are facing the front of the rack.
Figure 107: Rail Safety Latch
4. Part Replacement
4.8 Rails Replacement
104