Fortinet FortiWiFi FortiWiFi-60B Install Manual page 71

FortiWiFi Firmware
5
6
7
8
9
10
11
FortiWiFi-60B FortiOS 3.0 MR6 Install Guide
01-30006-0447-20080131
To confirm the FortiWiFi unit can connect to the TFTP server, use the following
command to ping the computer running the TFTP server. For example, if the IP
address of the TFTP server is 192.168.1.168:
execute ping 192.168.1.168
Enter the following command to restart the FortiWiFi unit.
execute reboot
The FortiWiFi unit responds with the following message:
This operation will reboot the system!
Do you want to continue? (y/n)
Type y.
As the FortiWiFi unit starts, a series of system startup messages appears. When
the following messages appears:
Press any key to display configuration menu..........
Immediately press any key to interrupt the system startup.
Note: You have only 3 seconds to press any key. If you do not press a key soon enough,
FortiWiFi
the unit reboots and you must log in and repeat the execute reboot
command.
If you successfully interrupt the startup process, the following messages appears:
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[Q]: Quit menu and continue to boot with default
firmware.
[H]: Display this list of options.
Enter G, F, Q, or H:
Type G to get to the new firmware image form the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
Type the address of the TFTP server and press Enter:
The following message appears:
Enter Local Address [192.168.1.188]:
Type an IP address the FortiWiFi unit can use to connect to the TFTP server. The
IP address can be any IP address that is valid for the network the interface is
connected to. Make sure you do not enter the IP address of another device on this
network.
The following message appears:
Enter File Name [image.out]:
Enter the firmware image filename and press Enter.
The TFTP server uploads the firmware image file to the FortiWiFi unit and a
message similar to the following appears:
Save as Default firmware/Backup firmware/Run image without
saving: [D/B/R]
Installing firmware from a system reboot using the CLI
71