Backup And Restore From A Usb Key; Using The Usb Auto-Install - Fortinet FortiWiFi FortiWiFi-60B Install Manual

FortiWiFi Firmware

Backup and Restore from a USB key

1
2
3
4
1
2
3
4

Using the USB Auto-Install

1
2
3
4
5
6
FortiWiFi-60B FortiOS 3.0 MR6 Install Guide
01-30006-0447-20080131
Use a USB key to either backup a configuration file or restore a configuration file.
You should always make sure a USB key is properly install before proceeding
since the FortiWiFi unit must recognize that the key is installed in its USB port.
Note: You can only save VPN certificates if you encrypt the file. Make sure the
configuration encryption is enabled so you can save the VPN certificates with the
configuration file. An encrypted file is ineffective if selected for the USB Auto-Install feature.
To backup configuration
Go to System > Maintenance > Backup and Restore.
Select USB Disk from the backup configuration to list.
Enter a file name for the configuration file.
Select Backup.
To restore configuration
Go to System > Maintenance > Backup and Restore.
Select USB Disk from the restore configuration from list.
Select a backup configuration file from the list.
Select Restore.
The USB Auto-Install feature automatically updates the FortiGate configuration
file and image file on a system reboot. Also, this feature provides you with an
additional backup if you are unable to save your system settings before shutting
down or rebooting your FortiWiFi unit.
Note: You need an unencrypted configuration file for this feature. Also the default files,
image.out and system.conf, must be in the root directory of the USB key.
Note: Make sure at least FortiOS v3.0MR1 is installed on the FortiWiFi unit before
installing.
To configure the USB Auto-Install
Go to System > Maintenance > Backup and Restore.
Select the blue arrow to expand the Advanced options.
Select the following:
• On system restart, automatically update FortiGate configuration file if default
file name is available on the USB disk.
• On system restart, automatically update FortiGate firmware image if default
image is available on the USB disk.
Enter the configuration and image file names or use the default configuration
filename (system.conf) and default image name (image.out).
The default configuration filename should show in the Default configuration file
name field.
Select Apply.
Using the web-based manager
67