Fortinet FortiWiFi FortiWiFi-60B Install Manual page 60

Configuring the modem using the CLI
60
Keywords and variables
holddown-timer <seconds>
idle-timer <minutes>
interface <name>
mode {redudant |
standalone}
modem-dev1{internal |
pcmica-wireless}
modem-dev2{internal |
pcmica-wireless}
modem-dev3{internal |
pcmica-wireless}
passwd1 <password_str>
passwd2 <password_str>
passwd3 <password_str>
peer-modem1
{actiontec | ascendTNT
| generic}
peer-modem2
{actiontec | ascendTNT
| generic}
peer-modem3
{actiontec | ascendTNT
| generic}
Configuring the modem interface
Description
Used only when the modem is
configured as a backup for an
interface. Set the time (1-60 seconds)
that the FortiWiFi unit waits before
switching from the modem interface to
the primary interface, after the primary
interface has been restored.
This is available only when mode is set
to redundant.
Set the number of minutes the modem
connection can be idle before it is
disconnected.
This is available only if mode is set to
standalone.
Enter an interface name to associate
the modem interface with the ethernet
interface that you want to either back
up (backup configuration) or replace
(standalone configuration).
Enter the required mode:
• redundant
The modem interface automatically
takes over from a selected ethernet
interface when that ethernet interface
is unavailable.
• standalone
The modem interface is the connection
from the FortiWiFi unit to the Internet.
Set the modem type for the selected
dialup account.
Set the modem type for the selected
dialup account.
Set the modem type for the selected
dialup account.
Enter the password used to access the
specified dialup account.
Enter the password used to access the
specified dialup account.
Enter the password used to access the
specified dialup account.
If the modem at phone1 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
If the modem at phone2 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
If the modem at phone3 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
FortiWiFi-60B FortiOS 3.0 MR6 Install Guide
01-30006-0447-20080131
Default
60
5
No default.
standalone
internal
internal
internal
No default.
No default.
No default.
generic
generic
generic