Table of Contents
Advertisement
FortiGate-50R Installation and Configuration Guide Version 2.50 MR2
Transparent mode installation
Preparing to configure Transparent mode
FortiGate-50R Installation and Configuration Guide
This chapter describes how to install your FortiGate unit in Transparent mode. If you
want to install the FortiGate unit in NAT/Route mode, see
installation" on page
33.
This chapter describes:
•
Preparing to configure Transparent mode
•
Using the setup wizard
•
Using the command line interface
•
Connecting the FortiGate unit to your networks
•
Completing the configuration
•
Transparent mode configuration examples
Use
Table 14
to gather the information that you need to customize Transparent mode
settings.
Table 14: Transparent mode settings
Administrator Password:
Management IP
The management IP address and netmask must be valid for the network
from which you will manage the FortiGate unit. Add a default gateway if the
FortiGate unit must connect to a router to reach the management
computer.
DNS Settings
IP:
Netmask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server: _____._____._____._____
"NAT/Route mode
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
41
Advertisement
Table of Contents
