Adding firewall policies
Firewall policy options
116
Figure 5: Adding a NAT/Route policy
This section describes the options that you can add to firewall policies.
Source
Select an address or address group that matches the source address of the packet.
Before you can add this address to a policy, you must add it to the source interface. To
add an address, see
"Addresses" on page
Destination
Select an address or address group that matches the destination address of the
packet. Before you can add this address to a policy, you must add it to the destination
interface. To add an address, see
122.
"Addresses" on page
122.
Firewall configuration
Fortinet Inc.