Table of Contents
Advertisement
Preparing to configure NAT/Route mode
Changing the default configuration
Preparing to configure NAT/Route mode
34
To use the factory default configuration, follow these steps to install the FortiGate unit:
1
Configure the TCP/IP settings of the computers on your internal network to obtain an
IP address automatically using DHCP. Refer to your computer documentation for
assistance.
2
Complete the procedure in the section
networks" on page
You can use the procedures in this chapter to change the default configuration. For
example, if your ISP assigns IP addresses using PPPoE instead of DHCP, you only
need to change the configuration of the external interface. Use the information in the
rest of this chapter to change the default configuration as required.
Use
Table 12
to gather the information that you need to customize NAT/Route mode
settings.
Table 12: NAT/Route mode settings
Administrator password:
Internal
interface
External
interface
Internal servers
"Connecting the FortiGate unit to your
37.
IP:
Netmask:
IP:
Netmask:
Default Gateway:
Primary DNS Server:
Secondary DNS Server:
Web Server:
SMTP Server:
POP3 Server:
IMAP Server:
FTP Server:
If you provide access from the Internet to a web server, mail server, IMAP
server, or FTP server installed on an internal network, add the IP
addresses of the servers here.
NAT/Route mode installation
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
Fortinet Inc.
Advertisement
Table of Contents
