Transmit Records To Host; Batch Mode Transmit Delay; Multiple Scanner Operation - Honeywell Xenon Series User Manual

Transmit Records to Host

If you are operating in Inventory Batch Mode (see
62), you must scan the following bar code to transmit all the stored data to the host
system.

Batch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the transmission
of those scans is too fast for the application to process. To program a transmit
delay between accumulated scans, scan one of the following delays. Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays
may be programmed. Contact Technical Support
information.
* Batch Mode Transmit Delay Off
Batch Mode Transmit Delay Medium

Multiple Scanner Operation

Note: Multiple Scanner Operation Mode allows you to link up to 7 scanners to one base or
Access Point. You cannot join an 8th scanner until you unlink one of the 7 scanners
or take a scanner out of range.
Xenon/Granit User Guide
(No Delay)
(500 ms)
Inventory Batch Mode
Transmit Inventory Records
(page xvii) for additional
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Long
(1000 ms)
on page
67