Batch Mode Quantity; Enter Quantities - Honeywell Xenon Series User Manual

Batch Mode Quantity

When in Batch Mode, you may wish to transmit the number of multiple bar codes
scanned, rather than a single bar code multiple times. For example, if you scan
three bar codes called XYZ with Batch Mode Quantity Off, when you transmit your
data it will appear as XYZ three times. Using Batch Mode Quantity On and the
Quantity Codes
Note: If you wish to format your output, for example, place a CR or tab between the bar code
data and the quantity, refer to
Default = Batch Mode Quantity Off.

Enter Quantities

Quantity Codes
up to 9999 (default = 1). Quantity digits are shifted from right to left, so if a 5th digit
is scanned, the 1st digit scanned is discarded and the 2nd, 3rd and 4th digits are
moved to the left to accommodate the new digit.
For example, if the Quantity 5 bar code is scanned after the quantity has been set
to 1234, then the 1 is dropped, the quantity will be 2345.
Example: Add a quantity of 5 for the last item scanned.
1. Scan the item's bar code.
2. Scan the quantity 5 bar code.
Example: Add a quantity of 1,500 for the last item scanned.
1. Scan the item's bar code.
2. Scan the quantity 1 bar code.
3. Scan the quantity 5 bar code.
4. Scan the quantity 0 bar code.
5. Scan the quantity 0 bar code.
Example: Change a quantity of 103 to 10.
To correct an incorrect quantity, scan the quantity 0 bar code to replace the incor-
rect digits, then scan the correct quantity bar codes.
64
(page
* Batch Mode Quantity Off
(page
65), you could output your data as "XYZ, 00003" instead.
Data Format
65) allow you to enter a quantity for the last item scanned,
beginning on page 167.
Batch Mode Quantity On
Xenon/Granit User Guide